Replaces
This part doesn’t fit a . Select from parts that fit.
1A Auto Lifetime Warranty
Frequently bought together
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Returns: Parts with electrical components cannot be returned once installed.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Don from 1A Auto. I hope this how-to video helps you out, and the next time you need a part for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to replace the master switch pack on a 2006 Chevy Impala. It's very similar for model years 2006 through 2012. You'll need a new master switch pack from 1A Auto, as well as a T30 Torx bit, extension, socket wrench, and a flat blade screwdriver.
In the inner door handle you'll find a little rubber mat. Use a little pocket screwdriver and pull that out. Then beneath that, you're going to find two T30 Torx screws. Use a T30 Torx bit and socket wrench and driver. Using an extension, get down to those so we can remove them.
Once you have those out, use a little small pocket screwdriver and pry up on that black plastic housing there that holds the handle and the switch pack assembly. You're going to find three connectors. Remove the three connectors by pressing in on the tabs and pulling them out. You'll see the four tabs that hold the switch pack to the housing.
Using a small pocket screwdriver to pry between, I'm also applying pressure with my left hand so that the switch pack starts to pop up and out.
You see the switch pack just goes in from the bottom and clicks in.
Plug the three connectors back into the master switch pack and to your power mirror switch. Set the handle and switch pack assembly back in, and start to reinstall your Torx screws. Reinstall those T30 Torx screws, tighten them down, and then place that mat back on top of them.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
