Replaces
Replaces Ford 8 Piece Ignition Kit TRQ TKA06183
$122.95
Replaces Ford Mercury 8 Piece Ignition Kit DIY Solutions IGN01221
$117.95
Replaces Ford Explorer Mercury Mountaineer 8 Piece Ignition Kit DIY Solutions IGN01209
$117.95
Replaces Ford Explorer Mercury Mountaineer 8 Piece Ignition Kit TRQ TKA06181
$112.95
Replaces Ford Ranger Mazda B3000 8 Piece Ignition Kit TRQ TKA19512
$110.95
Replaces Ford Explorer Mercury Mountaineer 8 Piece Ignition Kit TRQ TKA06182
$109.95
Replaces 1996 Ford Ranger V6 4.0L 8 Piece Ignition Kit TRQ TKA19510
$108.95
Replaces 1997-00 Ford Explorer Ranger Mazda B4000 8 Piece Ignition Kit TRQ TKA19506
$105.95
Replaces Ford Mercury 2 Piece Ignition Kit TRQ ICA65544
$89.95
Replaces Ford Explorer Mercury Mountaineer 2 Piece Ignition Kit TRQ ICA60069
$87.95
Replaces Ford Ignition Kit TRQ TKA01270
$87.95
Replaces 2005-10 Ford Mustang V6 4.0L 2 Piece Ignition Kit TRQ ICA66256
$84.95
Replaces Ford Mazda Spark Plug Wire Set TRQ IWA69077
$64.95
Replaces Ford Mazda Mercury Ignition Coil TRQ ICA61396
$54.95
Part Details
Product Features
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Returns: Parts with electrical components cannot be returned once installed.
Created on:
Tools used
Tools used
Tools used
Tools used
We have a clear view of our coil and, of course, our wires. We're lucky enough that ours are numbered. So, this one right here is number five, number six, number four. Right here, you have number three, number two, and number one. Draw a picture, take a picture. Remember, that's the way they go. Let's start disconnecting them. Squeeze those tabs. It should want to lift up. There we are. Awesome. Let's move along to grabbing this wiring harness, small pocket screwdriver, lift up on the tab. Draw that off. Next, we're gonna remove the four mounting bolts that go around the corners using a 7-millimeter. We've got our new coil. Sit it right on there. Four mounting bolts. Go ahead and start them in. Just remember this one right here had this little guy. Snug them up. Awesome. Let's get these wires back on here. If you don't have any lubricant in there, this actually has a little bit of dielectric, so I'm gonna leave it alone. But it's a good idea to have a teeny bit in there. Let's push this down. I've got number one, number two. You definitely wanna make sure both ends are over, that way there you know for sure it's locked in. This one goes like that. That's number three. We're gonna come up here, get number four, it's gonna go under there. There it is. Number six is in the center. It's definitely down. Next one. Okay. Just make sure all your wires are nice and secure. So, we've got our electrical connector. I'm just going to line it up, click it in, give it a tug. Awesome.
