2005 Mercury Mountaineer V6 4.0L Flex Fuel 8th Vin Digit K 8 Piece Ignition Kit TRQ TKA06182

We have a clear view of our coil and, of course, our wires. We're lucky enough that ours are numbered. So, this one right here is number five, number six, number four. Right here, you have number three, number two, and number one. Draw a picture, take a picture. Remember, that's the way they go. Let's start disconnecting them. Squeeze those tabs. It should want to lift up. There we are. Awesome. Let's move along to grabbing this wiring harness, small pocket screwdriver, lift up on the tab. Draw that off. Next, we're gonna remove the four mounting bolts that go around the corners using a 7-millimeter. We've got our new coil. Sit it right on there. Four mounting bolts. Go ahead and start them in. Just remember this one right here had this little guy. Snug them up. Awesome. Let's get these wires back on here. If you don't have any lubricant in there, this actually has a little bit of dielectric, so I'm gonna leave it alone. But it's a good idea to have a teeny bit in there. Let's push this down. I've got number one, number two. You definitely wanna make sure both ends are over, that way there you know for sure it's locked in. This one goes like that. That's number three. We're gonna come up here, get number four, it's gonna go under there. There it is. Number six is in the center. It's definitely down. Next one. Okay. Just make sure all your wires are nice and secure. So, we've got our electrical connector. I'm just going to line it up, click it in, give it a tug. Awesome.