Replaces
Part Details
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to replace the tailgate handle. The one on our truck is functioning fine, so we just actually take it off and put it back on to show you how to do it. Tools you'll need include a T30 Torx bit and a 10mm socket, and you'll also need a ratchet.
You're going to have to use a T30 Torx bit and remove all the bolts that hold on the backing panel on your bed here. I'm going to cheat a little bit by using a ratchet, an air ratchet. Now I'll speed it up here as I remove all those bolts. I'm going to pull this up and off.
Now, inside, we can see how it works. A lot of times what happens is this part right here breaks off, or this shears off. You can see mine's in good shape, so I'm going to take it off and put it back on to show you.
These clips just push off the rods. Now we have to remove these two 10mm bolts. Once you get those out there's two little pins. You just get those out, and then your handles out.
Reinstallation, pretty much a reverse of the procedure, you put it up in; begin your bolts in a little way. You don't' want to over tighten these, get them nice and snug. Then the rods back in, the clip back on. The red rod goes to the top.
A little high speed action here as you slip that panel back in and then put all the bolts back in. One note: the ones that run along the top, they have the larger washers.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
