Replaces
This part doesn’t fit a . Select from parts that fit.
1A Auto Lifetime Warranty
Frequently bought together
Part Details
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to replace the hood support struts. The procedure is the same for any 2002 to 2005 Mountaineer as well as the Ford Explorer. You'll need new hood support struts from 1AAuto.com and a small flat blade screwdriver.
You can see, when we lift our hood, it just falls right back down again. This is a sign that your hood supports have gone bad. You want something or someone to support the hood while you do this procedure. We're going to use this block of wood. To remove these supports just take a flat blade screwdriver. Pry out on this clip. Then pull the piston from the stud. Then do the same thing down here. It pulls free. We're going to replace both of our hood supports. We'll just fast forward as Mike removes the other one.
Up top are the old hood supports. Below are the new ones from 1A Auto. You can see they're identical and they'll fit exactly the same. Now, to replace your hood support pistons, just push them onto the studs. You may need to lift the hood a little bit to get it to go onto the stud. Then we'll just repeat that process over here. Do the same thing: just push it onto the studs. Now you no longer have to support your hood. You just test it out. Close it. Open it back up. It should practically open itself. You're all set.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
Tools used
