Replaces
This part doesn’t fit a . Select from parts that fit.
1A Auto Lifetime Warranty
Frequently bought together
This hood release handle is a new, aftermarket replacement part. It is just what you need to replace broken or defective handle so you will be able to open your hood again!
Specifications:
This hood release handle makes a great replacement and has good cost savings over a dealer unit.
Install Tip: Keep & reuse your original hardware, new hardware is not included with this item.
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Acrylonitrile and Butyl benzyl phthalate (BBP)d, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Hi, I'm Mike from 1AAuto. We've been selling auto parts for over 30 years! We're dedicated to delivering quality auto parts, expert customer service, and fast and free shipping, all backed by our 100% satisfaction guarantee. So visit us at 1AAuto.com, your trusted source for quality auto parts.
Remove the kick panel on the driver's side by grabbing the top and popping it back. You can then move it around the weather strip in the door and slide it out of the way. You can see our old hood latch release cable is already broken. There are two tabs, one on each side that you'll need to pop in, and slide the cable out of it. This is all that's left of our old part.
Using the T40 Torx socket and a ratchet, remove the T40 Torx bolt that was securing what was left of our hood latch release handle to the body.
Put the cable through the new hood latch release handle, and install the cable into the actual handle. That kind of twist it through the opening there. You have to pull it some. It may help to use a small screwdriver just to get a little better leverage on it, set it in like that. Set up the little alignment pin into the body and start your T40 Torx screw.
Tighten that down with your T40 Torx socket and ratchet. Reinstall your interior trim panel. Be sure to get the bottom under the rocker panel. There's a little alignment pin in there. Line up the top, push firmly to reengage the clips and you're good to go.
Thanks for watching. Visit us at 1AAuto.com for quality auto parts, fast and free shipping, and the best customer service in the industry.
